Lubrication
Points requiring periodic lubrication are:
A.Column. A light film of oil (Mobil Vactra 2 or ISO 68 equivalent) will smooth action and prevent rust and corrosion.
B.Column Rack. Lubricate every 90 days with NLGI #2 grease.
C.Quill. A light coating of oil (Mobil Vactra 2) will ensure smooth movement.
D.Quill Rack. Lubricate every 90 days with NLGI #2 grease.
E.Table Leadscrews. Lubricate once each week with several drops of Mobil Vactra 2 or way oil. Refer to Table Leadscrews on this page for more information on this procedure.
F.Ball Oilers. Wipe the outer surface of the ball fitting with a clean cloth to remove contami- nants. Press the ball of the fitting with the tip of the oiler. Press a few drops of Mobil Vactra 2 or way oil into the ball fitting, then clean up any residue with a cloth.
G.Ways. Periodically lubricate the ways with Mobil Vactra 2 or way oil.
F
B | C |
A | F |
D | E |
F | F |
| E |
| G |
Figure 54. Ball oiler locations.
Model G0705 (Mfg. since 09/09)
Table Leadscrews
Every six months, or more frequently under heavy use, clean and lubricate the leadscrews.
Items Needed: |
| Qty |
Mobil Vactra 2 or ISO 68 Equivalent | 1 | |
1 | ||
Mineral Spirits | As needed for cleaning | |
Shop Rags | As needed for cleaning | |
To lubricate the leadscrews:
1.DISCONNECT MILL/DRILL FROM POWER!
2.Using the cross handwheel, move the table as far forward as possible.
3.Lift or remove the rubber way cover, then use mineral spirits and a brush to clean as much of the existing oil and debris as possible off of the cross travel leadscrew shown in Figure 55. Allow the leadscrew to dry.