Loading Tooling
The Model G0705 features an
To install tooling:
1.DISCONNECT MACHINE FROM POWER!
2.Release the latches on the head cover and open it.
3.Make sure the tapered mating surfaces of the cutting tool and the spindle are clean and free of grease or other contaminants.
4.Insert the cutting tool's arbor up into the spin- dle housing. Rotate the tooling to line up the keyway with the matching pin in the spindle opening.
5.Turn the hex head at the top of the drawbar (located on the top, front of the head) clock- wise, as shown in Figure 36 until the threads at the bottom of the drawbar mesh with the female threads in the top of the collet/arbor.
Drawbar |
Arbor |
Figure 36. Collet/arbor installation.
6.If you're using a collet, insert the cutter in the hole at the bottom of the collet. Be sure to protect your hands from the cutter with leather gloves or a shop rag.
7.Continue to tighten the drawbar until both the collet and cutter or arbor are tightly in place. Do not over-tighten the drawbar and never use power tools to tighten it.
—If the drawbar bottoms out in the tooling and will tighten no farther before the tooling is tight in the spindle, tighten the drawbar lock nut to secure the tooling in the spindle.
To remove tooling:
1.DISCONNECT MACHINE FROM POWER!
2.Loosen, but do not remove the drawbar.
3.Hold the tooling with a shop towel to prevent it from dropping completely out of the machine. Tap on the top of the drawbar with a brass hammer to loosen the collet/arbor from the spindle, as shown in Figure 37.
Drawbar |
Arbor |