BM 2610000813
Assembly
Disconnect battery pack ! WARNING from tool before making
any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
INSERTING BITS
Move reverse switch lever to the center “OFF” position. Remove battery pack and rotate the clutch ring to the drill bit symbol
“
”. Rotate the chuck sleeve counter- clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Close chuck by rotating the chuck sleeve clockwise and securely tighten by hand (Fig. 2).
Do not use the power of ! WARNING the drill while grasping
chuck to loosen or tighten bit. Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
FIG. 2 | CHUCK SLEEVE |
|
SCREWDRIVER
BIT
BIT HOLDER
SCREWDRIVER BIT
REMOVING CHUCK
Rotate the clutch ring to the drill bit
symbol “
”. Open the chuck all the way, remove
Insert the short arm of a 3/8" hex key wrench and close jaws on flats of wrench (Fig. 4). Strike long arm of wrench sharply
counterclockwise, remove wrench and unthread chuck from spindle.
INSTALLING CHUCK
Always keep the spindle threads, the threads of the chuck and securing screw free of debris. To install a chuck, reverse “removing the chuck” procedure.
FIG. 3 | FIG. 4 |
CHUCK SLEEVE 
Operating Instructions
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. 1).