Section 8 - Welder Data Export Software
Introduction
A Windows™ application named Dual Servo Spin Welder Utility, can be used to capture data exported by the welder to a PC. This application is also capable of importing the servo tuning database, and obtaining messages from the machine that may be useful in trou- bleshooting.
Hardware and
Software Requirements
The utility requires a PC or laptop running a Windows 2000™, XP™, or Vista™ operating system. A straight
Installation,
Startup, and Cable
Connections
To install the program, Run the setup.exe file located in the Dukane Dual Servo Spin Utility Installer folder on the CD supplied with the welder and follow the prompts on the screen.
Once installed, run the program. It can be accessed through:
Start Menu
Servo SpinWelder Utility
Connect the cable between the Data Port on the weld- er (located above the power switch on the rear of the welder) and a serial port on the PC or a
PARAMETER | VALUE |
|
|
Baud Rate | 57600 |
|
|
Data Bits | 8 |
|
|
Parity | NONE |
|
|
Stop Bits | 1 |
|
|
Flow Control | Xon/ Xoff |
|
|
Dukane Manual Part No. | Page 67 |