Carrier 50PEC09-18 specifications A50-8452

a50-8452

Complete C

SEE NOTE 9

Complete C

		LEGEND
AL	—	Alarm Relay Contacts		Relay/Contactor Coil
BM	—	Blower Motor
BR	—	Blower Relay
CAP	—	Capacitor		Solenoid Coil
CB	—	Circuit Breaker
CO	—	Sensor, Condensate Overflow		Thermistor
CR	—	Compressor Relay
DM	—	Damper Motor		Circuit Breaker
FP1	—	Sensor, Water Coil Freeze Protection		Relay Contacts-N.O.
FP2	—	Sensor, Air Coil Freeze Protection
HP	—	High-Pressure Switch		Switch-Temperature
JW1	—	Jumper Wire for Alarm
LOC	—	Loss of Charge Pressure Switch		Switch-High Pressure
PB	—	Power Terminal Block
RAS	—	Return Air Sensor		Switch-Low Pressure
RVS	—	Reversing Valve Solenoid
TRANS	—	Transformer		Ground
WV	—	Water Valve
----------		Field Line Voltage Wiring		Wire Nut
		Field Low-Voltage Wiring	>>	Mate-N-Lok

Printed Circuit Trace	*Optional wiring.
Option Low Voltage Wiring
	†Registered trademark of AMP Incorporated.

BLOWER MOTOR WIRING

UNIT SIZE	POLE A	POLE B
09-18	5	4

NOTES:

1.Compressor and blower motor thermally pro- tected internally.

2.All wiring to the unit must comply with local codes.

3.Transformer is wired to 115-V (WHT) lead for 115/1/60 units; 265-V (BRN) lead for 265/1/60 units; or 208-V (RED) lead for 208/1/60 units.

For 230/1/60 operation, switch the RED and ORG leads at L1 and insulate the RED lead. Transformer is energy limiting or may have a circuit breaker.

4.FP1 thermistor provides freeze protection for WATER. When using ANTI-FREEZE solutions, cut JW3 jumper.

5.For remote sensor, position jumper J1 on upper 2 pins.

6.For °F position, position jumper on both pins. For °C, position jumper on one pin.

7.Transformer secondary ground via Complete C board standoffs and screws to control box. (Ground available from top two standoffs as shown.)

8.Mate-N-Lok† plug is optional.

9.Factory-cut jumper (JW1). Dry contact will be available between AL1 and AL2.

Fig. 17 — 50PEC Unit Manual or Auto Changeover with Complete C Controller Wiring

18