Miller Electric XR Control manual Threading Welding Wire Through Feeder, It from unraveling

5-12. Threading Welding Wire Through Feeder

Tools Needed:	Hold wire tightly to keep
	it from unraveling.

6 in (150 mm)

Open tension arm. Pull and hold wire; cut off end.

Proceed to Section 5-13.

Thread wire thru inlet guide, along drive roll groove, and into wire conduit. Close tension arm. Adjust tension as follows: grasp spool with one hand, press Jog switch, and turn thumb nut clockwise until motor stalls when Jog switch is pressed. Back thumb nut off slightly.

Ref. 802 193-A

OM-1594 Page 22