Miller Electric XR Control manual Symbols And Definitions, Specifications, Diameter, Power

3-3. Symbols And Definitions

Note	Some symbols are found only on CE products.
A	Amperes	V	Volts		Alternating Current	X	Duty Cycle
IP	Degree Of	Hz	Hertz		Circuit Breaker		Wire Feed
	Protection
	Jog		Output		Trigger		Gun
	Press To Set		Increase		Trigger Hold On		Trigger Hold Off
	Purge		Spot Weld Time		Percent		Run-In
	Burnback Time	U1	Primary Voltage	U2	Load Voltage		Read Instructions
I1	Primary Current	I2	Rated Current		Line Connection		Water (Coolant) In-
							put
	Water (Coolant)		Fuse		Continuous
	Output				Spot Welding

SECTION 4 − INTRODUCTION

4-1. Specifications

Type of Input	Welding Power	Wire Feed	Wire	Welding	Overall
			Diameter			Weight
Power	Source Type	Speed Range		Circuit Rating	Dimensions
			Range
				All Models: 100%
	Constant Voltage (CV)		.030 To .062 in	Duty Cycle, 100	Length: 21-1/4 in
24 Volts AC	DC For GMAW Or		(0.8 To 1.6	Volts;	(540 mm)
	Constant Voltage(CV) /	70 To 875 ipm (1.8	mm)	Water-Cooled	Width: 9-1/2 in	38 lb
Single-Phase	Constant Current (CC) DC			Models: 400
5 Amperes		To 22.2 mpm)			(241 mm)	(17.2 kg)
	For GMAW-P		Max Spool	Amperes,
50/60 Hertz
	All Need 14-Pin And		Capacity: 12 in	Air-Cooled	Height: 16 in
	Contactor Control		(305 mm)	Models: 200	(406 mm)
				Amperes

OM-1594 Page 11