DH44 4 Source, 4 Zone Digital Audio Router
Auxiliary Power Connector (AUX POWER OUT)
For wire runs over 150’, it is recommended to run an additional 16 AWG/2 conductor wire from the
To make connections:
1.Ensure that system power is OFF!
2.Strip the ends of the 16 AWG wire 1/4" on both ends of the wire run.
3.Remove the terminal strip from the AUX POWER OUT connector on the DH44.
4.Loosen the screws for the appropriate zone’s terminal pairs on the terminal strip.
5.Insert the wires into the terminal strip, paying close attention to polarity
6.Tighten the screws on the terminal strip.
7.Remove the terminal strip from the PWR IN connector of the DHTP1.
8.Loosen the screws on the DHTP1’s PWR IN terminal.
9.Insert the wires into the terminal, paying close attention to polarity
10.Tighten the screws on the DHTP1’s PWR IN terminal.
11.Connect the terminal strip back onto the AUX POWER OUT connector on the DH44
DHTP1 Rear
L+ L- R+ R-
SPEAKERS
16/2
- +
PWR IN
DH44
Figure 3-11: AUX POWER OUT Connections
USB Port (USB IN)
The USB IN port is designed to allow upgrades to the DH44’s fi rmware.
AC Power Connector
Connect the supplied cord from the AC Power Connector into a properly grounded electrical outlet.
20 | ©2008 • All rights reserved. |