Delta 31-483 operating instructions Table of Contents, Important Safety Instructions

TABLE OF CONTENTS

IMPORTANT SAFETY INSTRUCTIONS	2
safety guidelines - definitions	3
GENERAL SAFETY RULES	3
Power Connections	5
Motor Specifications	5
Grounding Instructions	5
Extension Cords	6
Features and Components	6
Functional Description	7
Product Specifications	7
Unpacking	7
Assembly	8
Install Sanding Sleeves on Spindles	8
Install Spindles	8
Select and Install the Table Insert	9
Connect to Dust Collector	9
On-Board Storage for Spindles and Table Inserts	10

Operation	10
Adjustments	11
Adjusting Table Tilt	11
Squaring the Table to the Spindle	11
Recommended Maintenance	12
Lubrication	12
Routine Inspection	12
Replacing Sanding Sleeves	12
Accessories	12
Warranty	13
Replacement Parts	13
Service and Repairs	13
FranÇais	14
ESPAÑOL	27

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below, may result in electric shock, fire, and/or

serious personal injury or property damage.

Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certain hazards involved with the operation of the product. Using the machine with respect and caution will considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or ignored, personal injury to the operator may result. Safety equipment such

as guards, push sticks, hold-downs, featherboards, goggles, dust masks and hearing protection can reduce your potential for injury. But even the best guard won’t make up for poor judgment, carelessness or inattention. Always use common sense and exercise caution in the workshop. If a procedure feels dangerous, don’t try it. Figure out an alternative procedure that feels safer. REMEMBER: Your personal safety is your responsibility. For additional information please visit our website www.DeltaMachinery.com.

This machine was designed for certain applications only. DELTA® Power Equipment Corporation strongly recommends that this machine not be modified and/or used for any application other than that for which it was designed. If you have any questions relative to a particular application, DO NOT use the

machine until you have first contacted DELTA® to determine if it can or should be performed on the product.

If you have any questions relative to its application DO NOT use the product until you have written DELTA® Power Equipment Corporation and we have advised you. Contact us online at www.DeltaMachinery.com or by mail at Technical Service Manager, DELTA® Power Equipment Corporation, 4825 Highway 45 North, Jackson, TN 38305.

Information regarding the safe and proper operation of this tool is available from the following sources:

•Power Tool Institute, 1300 Sumner Avenue, Cleveland, OH 44115-2851or online at www.powertoolinstitute.com

•National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201

•American National Standards Institute, 25 West 43rd Street, 4 floor, New York, NY 10036 www.ansi.org - ANSI 01.1 Safety Requirements for Woodworking Machines

•U.S. Department of Labor regulations www.osha.gov

2