ASSEMBLY
SELECT AND INSTALL THE
TABLE INSERT
Failure to use the proper insert with the corresponding spindle may result in injury and/or damage to the machine or the work piece.
Your DELTA® Heavy Duty Oscillating Bench Spindle Sander comes with four table insert plates. The two table inserts with the smaller diameter openings are designed for use with the ¼", ½", and 5/8" sanding spindles while the two table inserts with the larger openings are designed for use with the 1 ½’ and 2" sanding spindles.
The table inserts with the round openings are designed for sanding jobs where the table is in the fully horizontal position. The table inserts with the oblong openings are for beveled sanding.
SPINDLE SIZE | RECOMMENDED TABLE INSERT | |
(diameter) | Opening Size | Opening Shape |
|
|
|
¼" | Small | Oblong or Round |
|
|
|
½" | Small | Oblong or Round |
|
|
|
5/8" | Small | Oblong or Round |
1 ½" | Large | Oblong or Round |
2" | Large | Oblong or Round |
|
|
|
figure 5
• Using the recommended table inserts shown in Figure 5, select the desired table insert.
• Slip the table insert over the spindle. Ensure the table insert is properly seated by aligning the small notch in the table insert with the corresponding small tab in the table as shown in Figure 6.
figure 6
CONNECT TO A DUST COLLECTOR
Your DELTA® Oscillating Bench Spindle Sander is equipped with a 2" to 4" dust port adaptor that enables you to attach it to a standard dust collection system using either a 2" or 4" connection. This must be connected to dust collector hoses to ensure safe operation.
Do not attempt to operate this tool without first connecting it to an
adequate dust collection system.
Always turn on the dust collector before starting the sander and always stop the
sander before turning off the dust collector.
Locate the 2" diameter dust outlet on the rear of the machine (see Figure 7).
If your dust collector uses a 2" hose, attach it by fitting the hose over the existing dust port on the back of the sander.
If your dust collector has a 4" hose, fit the supplied | figure 7 |
2" to 4" adaptor over the existing dust port on the |
|
machine, then attach the hose from your dust collector |
|
to the 4" outlet on the adaptor. |
|
9