Functional Description, Product Specifications

FUNCTIONAL DESCRIPTION

Heavy Duty Oscillating Bench Spindle Sander is designed for sanding or polishing flat, round, or curved surfaces on wood and plastic materials.

PRODUCT SPECIFICATIONS

Oscillation rate	29 strokes/min
Oscillation stroke	15⁄16" (24 mm)

Spindle Speed	1720 Rpm

Motor	½ Hp, 110 V, 7.5 A
Table Size	14 ½ “ X 14 ½ “ (368 X 368 mm)

Table Tilt	0° to 45°, 0° to -45°

Spindle Size Range	¼ “ - 3" (6.2 - 50.8 mm)

Dust Chute	2" (50.8mm) with 4" (101.6mm) Adapter

Base Dimensions	14 ½ “ X 14 ½ “ (368 X 368 mm)
Weight	81 lbs (37 Kg)

Unpacking

The machine is heavy, be careful when removing it from the shipping container! Failure to comply may cause serious injury and/or damage to the sander and/or property!

Your DELTA® Heavy Duty Oscillating Bench Spindle Sander comes packed in a single container. Use a safety strap to avoid tip-over when lifting machine. Check shipping carton and machine for damage before unpacking.

Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean work surface and check that all parts are present and in good condition:

Description (Quantity)

Oscillating bench top spindle sander (1)	2" sanding spindle (1)	3/4" oblong table insert (1)
2" to 4" dust port adaptor (1)	1/4" sanding sleeve (1)	3/4" round table insert (1)
1/4" sanding spindle (1)	1/2" sanding sleeve (1)	2"oblong table insert (1)
1/2" sanding spindle (1)	5/8" sanding sleeve (1)	2" round table insert (1)
5/8" sanding spindle (1)	1 ½" sanding sleeve (1)	10-12 mm wrench (1)
1 ½" sanding spindle (1)	2“ sanding sleeve (1)	14-17 mm wrench (2)

Compare the items to inventory figures; verify that all items are accounted for before discarding the shipping box. Report any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.

Remove any protective materials and coatings from all of the parts and the drum sander. The protective coatings can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before all of the protective coatings are removed completely.

If any parts are missing, do not attempt to plug in the power cord and turn “ON" the machine. The machine should only be turned “ON" after all the parts have been obtained and installed correctly.