Delta SM600 instruction manual Assembly Time Estimate

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

1.) 4mm hex wrench - supplied 3.) 10mm wrench

2.) Quickset Blade Changing Wrench - supplied

ASSEMBLY TIME ESTIMATE

Less than one hour

1.Remove the blade from the scroll saw.

2.Move the blade lever tension handle (A) Fig. 3, to the foreword position as shown.

3.Push chuck locking lever (B) Fig. 4 to the rear as shown. This will release the blade (C) from the upper chuck assembly (D).

4.Insert long end (F) Fig. 5, of quickset blade changing wrench into hole (G) in lower blade holder. This will align wrench (H) with blade holder screw (J). Turn wrench (H) counter-clockwise. This will release the blade from the lower chuck assembly.

J

A

Fig. 3

D

BC

Fig. 4

H

GF

Fig. 5

7