Black & Decker SSL16 (16V MAX*), SSL20 Long storage will not harm the battery pack or charger

Page 6

Important Safety Instruction for Battery Packs

WARNING: For safe operation, read this manual and manuals originally supplied with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below. Then follow charging procedures outlined.

Read all Instructions

Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. Toxic fumes and materials are created when battery packs are burned.

Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery from the charger may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

Do not store or use the tool and battery pack in locations where the temperature may

 

reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

 

WARNING: Never attempt to open the battery pack for any reason. If battery pack

case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.

Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. NOTE: Lithium-

Ion batteries should not be put in checked baggage.

Storage Recommendations

 

1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2. Long storage will not harm the battery pack or charger.

Charging Procedure

A

Black & Decker chargers are designed to charge

Black & Decker battery packs in 3-4 hours depending

 

on the pack being charged.

 

1. Plug the charger into an appropriate outlet before

7

inserting the battery pack.

2. Insert the battery pack into the charger as shown in

 

figure A.

 

3. The green LED will flash indicating that the battery

 

is being charged.

 

4. The completion of charge is indicated by the green

 

LED remaining on continuously. The pack is fully charged

 

and may be used at this time or left on the charger.

 

Recharge discharged batteries as soon as possible after use or battery life may be greatly diminished. For longest battery life, do not discharge batteries fully. It is recommended that the batteries be recharged after each use.

Leaving the battery in the charger

The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.

6

Image 6 Contents
16V* MAX & 20V max** Cordless drills Safety Guidelines Definitions Work Area SafetySpecific Safety Rules Important Safety Instructions for Battery Chargers SSL16 SSL20 FUNCTIONAL DESCRIPTIONLong storage will not harm the battery pack or charger Black & Decker chargers are designed to chargeMay be used at this time or left on the charger Installing and Removing Battery Pack From the Tool Important Charging NotesTrigger Switch & Reversing Button Figure D Torque Control smart select technology Figure EOn board bit storage Figure G Make sure switch turns drill on and offScrew Driving DrillingTroubleshooting Service Information Full Two-Year Home Use Warranty See ‘Tools Electric’ Yellow Pages For Service SalesPerceuse Sans FIL DE 16V MAX*, 20V MAX Lignes directrices en matière de sécurité définitions Réparation Règles de sécurité spécifiques · le plomb dans les peintures à base de plombDescription Fonctionnelle Longueur totale de la rallonge Calibre de fil minimum recommandé pour les rallongesLire toutes les directives 25 piPeut être utilisé à ce moment-ci ou laissé sur le chargeur Si le bloc-piles ne se charge pas adéquatement, on doitAvertissement de sécurité et directives perceuses Insertion et retrait du bloc-piles de l’outilDirectives D’UTILISATION Détente ET Bouton Inverseur Figure DPerçage VissageRangement intégré des mèches Figure G Sceau Rbrcmc AccessoiresProblème Dépannage Solution possible Cause possible Maximiser la durée de vie duAccessoires Taladro Inalámbrico DE 16V MÁX*, 20V MÁX Pautas DE SEGURIDAD/DEFINICIONES Seguridad eléctricaNormas de seguridad específicas Símbolos Descripción DE LAS Funciones Daños personales y materialesPies Lea todas las instruccionesLongitud total del cable De la cubiertaRecomendaciones con respecto al almacenamiento Black & Decker en 3 a 4 horas según el paquete que se cargaEncenderla nuevamente Inferior del paquete de bateríasSuelte el disparador inmediatamente y Para instalar el paquete deInstrucciones DE Operación Las piezas de trabajo de material blandoTorsión o velocidad recomendada para esa aplicación Taladrado DestornilladoPor encima del paquete de baterías Tocino funciona tambiénEl sello Rbrc Asegúrese que el interruptor enciende y apaga el taladroAccesorios Paquete de baterías, este Maximizar la vida útil delPara que se cargue Solamente para Propósitos de MéxicoPage Telephone · No. Teléfono Años DE GarantiaPage Page Fernando González Armenta Htas. Portátiles de ChihuahuaFerre Pat de Puebla, S.A. de C.V Perfiles y Herramientas de Morelia
Related manuals
Manual 40 pages 55.72 Kb Manual 21 pages 42.56 Kb