Interoperability Testing
Running Session Tests (Client Mode)
Running Session Tests (Client Mode)
Normally you use this list of steps to verify connectivity and interoperability with a remote node. If the remote is not capable of receiving connections, or you wish to test the remote’s ability to establish connections, follow the instructions in “Running APRI Tests (Server Mode)” on page 21.
1.From root, type /opt/ots/bin/osidiag and select “Session Tests.”
2.Create a result file.
3.Make sure a server application is running on the remote, then: Select “Connect” from the Test Case menu.
4.Enter the destination Session Address when prompted. NOTE: osidiag will display the local address by default.
5.Check the “TEST STATUS” near the end of the report.
If the status is “PASSED,” you have successfully communicated with the remote node and are finished with this section.
If the status is “FAILED,” see “Interpreting Session Errors” on page 28 to find the problem.
If you find the error, rerun this test.
If you cannot find the error, enable tracing. See “Tracing and Logging through /opt/ots/bin/osidiag” on page 62.
6.Go to “Running APRI Tests (Server Mode)” on page 21 (Optional).
26 | Chapter 1 |