HP UX 11i v2 Networking Software manual Route Command Parameters, Dynamic Route Commands

Using OSI and OTS Tools

Dynamic Routing Commands

otsaddroute

ADD: Adds a single route entry for the specified subnetwork.

otsaddroute net_id subnet_name is_nsap [-mMask][-w]

otsdelroute

DELETE: Deletes the specified route entry.

otsdelroute net_id subnet_name [-mMask][-w]

otsshowroute

VIEW: Displays all route entries for the specified subnetwork. otsshowroute subnet_name

Route Command Parameters

Table 3-5		Dynamic Route Commands
	Argument	ots_routes	Description
		Parameter
	net_id	route_id	Specifies the end systems NSAP or network ID.
			If this value is the full length end-system
			NSAP, then this route entry will send
			information for this particular destination
			through the specified intermediate system
			(is_nsap). If this value is a prefix of an NSAP,
			then it is used to specify a group of systems, all
			having this common NSAP prefix.
	subnet_name	route_out_subnet	The symbolic name for the outgoing
			subnetwork to which the intermediate system
			is attached. This name must have been
			previously configured before OTS startup.
	is_nsap	route_primary	Specifies the intermediate system NSAP.
			Information destined for the end system will be
			sent through this system.

90 Chapter 3