HP UX 11i v2 Networking Software manual 0x08 Reject Nsap unreachable/ Permanent

Interoperability Testing

Reason and Refuse Codes

Code	Meaning	Action
(0x08)	N-Reject (NSAP unreachable/ Permanent)	Use osiadmin or otsshowes
	Network connection could not be established	to examine the configured
		X.121 address for this NSAP.
	because the X.121 address was incorrect.
		Verify if remote is up and
		listening on the configured
		address.
(0x09)	N-Reset from NS Provider (No Reason)	No recognized diagnostic is
	Network connection was reset.	provided.
(0x0a)	N-Reset from NS Provider (Congestion)	X.25 diagnostic indicates
	Network connection was reset.	provider was a problem.
(0x0b)	N_Reject (Address Unknown)	Use osiadmin or otsaddes
	No destination or route entry exists for the	to configure the destination
		system.
	given NSAP. Network connection cannot be
	established.
(0x12)	Disconnect for NS User Remote Transport
	layer encountered a failure and abruptly
	released the network connection.
(0x14)	User N_Reject (Transient)
	The remote Transport layer refused this
	network connection request.
(0x15)	User N_Reject (Permanent) The remote
	Transport layer refused this network
	connection request.
(0x16)	User N_Reject (QOS unavail/ Transient)
	QOS negotiation failure
(0x17)	User N_Reject (QOS unavail/ Permanent)
	QOS negotiation failure
(0x18)	N_Reject ((Unrecognized NS-user- data)

46 Chapter 1