HP UX 11i v2 Networking Software manual Common Logged Errors, Subsystem OTS, Error Description

Problem Solving

Common Logged Errors

		Common Logged Errors
		The following list describes some of the more common errors logged by
		OTS that you can encounter. These errors are sorted by the subsystem
		name and the message ID as it appears in the log.
Table 2-4		Subsystem OTS
	Error		Description
	[9600]		Indicates an error in the streams interface between user programs
	High Access		and the OTS stack in the kernel. One common problem is attempting
	Method ERROR		a bind operation to an invalid network address or SAP. Verify the
			local address used on your test and try again.
	[9800]		Indicates that the X.25 card has not been started or has gone down.
	x25 ERROR		Use otsstat and x25stat (or their equivalents under osidiag) to
			view the status of X.25. Restart X.25 if necessary under osiadmin.
Table 2-5		Subsystem ACSE_PRES
	Error		Description
	[6010]		Indicates that the presentation layer is releasing the connection
	P_DCNX_KO		after some error was encountered. Examine the log or user
			application for other errors.
	[6011]		Indicates a problem found by the presentation layer in the OTS
	PST_LOG		stack. This may indicate a protocol error, or an ASN.1 encoding issue.
			Examine the packets sent in the trace output.
Table 2-6		Subsystem SESSION
	Error		Description
	[5008]		Indicates that a session connection was not successfully established.
	S_REJECT		If the log does not show a T_REJECT error, this indicates that the
			problem was at the session layer. If a T_REJECT error is logged, then
			the S_REJECT is just a propagation of a Transport (or lower) layer
			problem.

Chapter 2 67