HP UX 11i v2 Networking Software manual Interpreting Transport Errors, Transport problem corrected

Interoperability Testing

Interpreting Transport Errors

Interpreting Transport Errors

		The following are possible situations you may currently find yourself in.
		Transport problem corrected.
		If you have made a change that corrected your Transport problem, then
		return to the Service Layer test that originally failed and try again.
		Configuration or other change required.
		If the corrective action in the following sections require you to change a
		configuration parameter or make some other change, then do so and
		rerun the Transport test.
		Problem persists.
		If you have been unsuccessful in correcting the problem, gather the
		information you have collected to provide to your HP support
		representative.
Table 1-4		Transport Call Errors
	Error		Reason	Action
	t_open()		The stack is most likely	Run status operation under
			not up.	Transport menu.
	t_bind()		Failed to associate an	Verify that the parameter
			address with the transport	tp_my_tsap is set to “diagt” or
			endpoint. Likely a	“diagt.NSAP” where NSAP is
			parameter error. Link	valid local address. Run status
			supporting this address	operation under Transport menu.
			went down.
	t_rcvdis()		Called to decode a	Check online error messages.
			disconnect indication.
	t_look()		Remote stack does not	Check to see if one node is
			respond for default time.	configured as NULL internet and
				other is not. Check for incorrect
				remote network address.

Chapter 1 33