1
2
3
4
To clear jams from inside the printer
CAUTION
Jams in this area might result in loose toner on the page. If you get toner on your clothes or hands, wash them in cold water. (Hot water will set the toner into the fabric.)
1Open the top cover.
2Remove the imaging drum by pushing it away from you and lifting it out of the printer. You cannot reach jams by removing the print cartridges.
3Complete one of these steps:
●If the leading edge of the paper is visible, carefully pull the paper out of the printer.
●If the paper is too difficult to remove, remove the jam as described in “To clear jams from output areas” on page 69.
4After the jam has been removed, replace the imaging drum and close the top cover.
5Press 
(GO) if the Go light is blinking. If the Attention light is still blinking, then another jam is present. See “To clear jams from input areas” on page 68 and “To clear jams from output areas” on page 69.
ENWW | Chapter 4 Problem solving and maintenance 67 |