HP 600n Print Server for Ethernet, 600n Print Server for Token Ring manual Introduction

Page 11

1

Introduction

The HP JetDirect 600N family of internal print servers are network interface cards for HP Enhanced I/O (EIO) printers and mopiers. With an HP JetDirect print server, you can connect and share your printer anywhere on your network and print at network speeds.

A typical network using an HP JetDirect 600N print server is illustrated below. The card must first be installed into the printer and connected to the network. Then, you must configure the card for network operation.

HP JetDirect 600N

●You can use HP JetDirect printer installation or management software. Refer to the HP JetDirect software installation instructions included with this product.

●Alternatively, for printers equipped with a control panel, you can use the printer’s control panel to configure basic network parameters. See chapter 3.

Introduction 1-1

Image 11

Contents HP JetDirect 600N Hardware Installation Guide Page Hardware Installation Guide HP JetDirect 600N Print Server Publication number HP J3112A for Token Ring Ieee 802.5 networks Quick InstallationIdentify Your HP JetDirect 600N Internal Print Server HP J3110A for Ethernet 10Base-T networksIf You Have a Token Ring Card If Necessary, Set Switches or Jumpers on Your CardBefore Installing the Card, Verify That Your Printer Works Print a Printer ConfigurationVerify That the Card Is Operating Properly Turn on the printer and print another configurationConfigure the Card for Network Operation Table of Contents Using the Embedded Web Server Introduction TCP/IP Supported Network ProtocolsIntroduction Supported PrintersIntroduction Installing the Print Server What You Need for Installation Identify Your HP JetDirect 600N Internal Print Server You can use only one Token Ring port RJ-45 or DB 10/100 Half/Full Autonegotiation If Necessary, Set Switches or Jumpers on Your CardHP LaserJet Printers and Mopiers Before Installing the Card, Verify That Your Printer WorksHP DesignJet Printers Service ConfigTurn Off Your Printer and Insert the Card Typical Card Installation and Network ConnectionVerify That the Card Was Installed Correctly For LocalTalk-Only Customers If you are For HP J3113A 10/100Base-TX cards SeeConfigure the Card for Network Operation HP JetDirect Administrator’s Guide provided on Installing the Print Server Control Panel Configuration Introduction To Enable or Disable Network Protocols To Restore Configuration Default ValuesPress Select. CFG NETWORK=YES* appears To enable or disable network protocolsFrame Type Description Configuring IPX Frame TypesIPX Frame Types on an HP JetDirect Ethernet Card IPX Frame Types on an HP JetDirect Token Ring CardCFG IPX/SPX=NO* is displayed To configure an IPX frame typeSource Routing Description Configuring IPX Source Routing Token Ring Cards OnlyTo configure IPX source routing Press Item until SRC RC=Source Routing* appears Parameter Description Configuring TCP/IP ParametersTo configure TCP/IP parameters CFG TCP/IP=NO* is displayed CFG ETALK=NO* is displayed To configure EtherTalk parametersPress Item. Etalk PHASE=1* or Etalk PHASE=2* appears Control Panel Configuration Using the Embedded Web Server Supported Web Browsers HP Web JetAdmin CompatibilityEmbedded Web Server Viewing the Embedded Web ServerOperating Notes LED State Description Off Not linked HP J3113A 10/100Base-TX Print Server Supported LinksLink-Speed LEDs Jumper Location Link Configuration Jumper SettingsJumper Setting Descriptions Parameter Expected Messages for 10/100TX Cards Link TroubleshootingHP J3113A 10/100Base-TX Print Server Environmental Specifications and Regulatory StatementsHP JetDirect 600N Internal Print Server ElectricalFCC Statements Regulatory StatementsElectromagnetic European Community Specifications RegulatorySpecifications and Regulatory Statements Vcci Class a Japan RRL Statement Korea Taiwan Class a AustraliaCanada Chinese Safety Statement Page 5969-3561