HP 600n Print Server for Token Ring, 600n Print Server for Fast Ethernet manual Publication number

Page 4

©Copyright Hewlett-Packard Company 2000. All rights reserved.

Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright laws.

Publication number

5969-3561

First Edition February 2000

Applicable Products:

J3110A

J3111A

J3112A

J3113A

Trademark Credits

Microsoft®, MS-DOS®, Windows®, Microsoft Windows NT® are trademarks or U.S. registered trademarks of Microsoft Corporation. NetWare® and Novell® are registered trademarks of Novell Corporation. IBM®, IBM LAN Server®, Operating System/2® are registered trademarks of International Business Machines Corp. Ethernet is a registered trademark of Xerox Corporation. PostScript® is a trademark of Adobe Systems, Incorporated. UNIX® is a registered trademark of the Open Group.

Disclaimer

The information contained in this document is subject to change without notice.

HEWLETT-PACKARD COMPANY MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance or use of this material.

Customer Support

For assistance, visit HP Customer Care Online at:

www.hp.com/support/net_printing

or refer to HP Customer Care By Phone described in the Quick Start Guide supplied with this product.

Warranty and Service

For product warranty and service information, refer to the Quick Start Guide supplied with this product.

A copy of the specific warranty terms applicable to your HP product and replacement parts can be obtained from your HP Sales and Service Office or Authorized dealer.

Safety Considerations

Prior to the installation and use of this product, review all safety markings and instructions.

Instruction Manual

!Symbol. If the product is marked with this symbol, refer to the product manuals to protect the product from damage.

WARNING

Denotes a hazard that

 

can cause injury

 

 

CAUTION

Denotes a hazard that

 

can damage equipment

 

or data.

Do not proceed beyond a WARNING or Caution notice until you have understood the hazard and have taken appropriate steps.

Grounding. This product is installed in a safety class 1 product that has a protective earthing terminal. There must be an uninterrupted safety earth ground from the main power source to the product’s input wiring terminals, power cord or supplied power cord set. Whenever it

is likely that the protection has been impaired, disconnect the power cord until the ground has been restored.

Hewlett-Packard Company

8000 Foothills Boulevard

Roseville, California 95747-6588

Image 4
Contents HP JetDirect 600N Hardware Installation Guide Page Hardware Installation Guide HP JetDirect 600N Print Server Publication number Quick Installation Identify Your HP JetDirect 600N Internal Print ServerHP J3110A for Ethernet 10Base-T networks HP J3112A for Token Ring Ieee 802.5 networksIf Necessary, Set Switches or Jumpers on Your Card Before Installing the Card, Verify That Your Printer WorksPrint a Printer Configuration If You Have a Token Ring CardTurn on the printer and print another configuration Verify That the Card Is Operating ProperlyConfigure the Card for Network Operation Table of Contents Using the Embedded Web Server Introduction Supported Network Protocols TCP/IPSupported Printers IntroductionIntroduction Installing the Print Server What You Need for Installation Identify Your HP JetDirect 600N Internal Print Server You can use only one Token Ring port RJ-45 or DB If Necessary, Set Switches or Jumpers on Your Card 10/100 Half/Full AutonegotiationBefore Installing the Card, Verify That Your Printer Works HP LaserJet Printers and MopiersService Config HP DesignJet PrintersTypical Card Installation and Network Connection Turn Off Your Printer and Insert the CardVerify That the Card Was Installed Correctly For HP J3113A 10/100Base-TX cards See For LocalTalk-Only Customers If you areConfigure the Card for Network Operation HP JetDirect Administrator’s Guide provided on Installing the Print Server Control Panel Configuration Introduction To Restore Configuration Default Values To Enable or Disable Network ProtocolsTo enable or disable network protocols Press Select. CFG NETWORK=YES* appearsConfiguring IPX Frame Types IPX Frame Types on an HP JetDirect Ethernet CardIPX Frame Types on an HP JetDirect Token Ring Card Frame Type DescriptionTo configure an IPX frame type CFG IPX/SPX=NO* is displayedTo configure IPX source routing Configuring IPX Source Routing Token Ring Cards OnlySource Routing Description Press Item until SRC RC=Source Routing* appears Configuring TCP/IP Parameters Parameter DescriptionTo configure TCP/IP parameters CFG TCP/IP=NO* is displayed Press Item. Etalk PHASE=1* or Etalk PHASE=2* appears To configure EtherTalk parametersCFG ETALK=NO* is displayed Control Panel Configuration Using the Embedded Web Server HP Web JetAdmin Compatibility Supported Web BrowsersViewing the Embedded Web Server Embedded Web ServerOperating Notes Link-Speed LEDs HP J3113A 10/100Base-TX Print Server Supported LinksLED State Description Off Not linked Jumper Setting Descriptions Link Configuration Jumper SettingsJumper Location Link Troubleshooting Parameter Expected Messages for 10/100TX CardsHP J3113A 10/100Base-TX Print Server Specifications and Regulatory Statements HP JetDirect 600N Internal Print ServerElectrical EnvironmentalElectromagnetic Regulatory StatementsFCC Statements Specifications Regulatory European CommunitySpecifications and Regulatory Statements Canada AustraliaVcci Class a Japan RRL Statement Korea Taiwan Class a Chinese Safety Statement Page 5969-3561