HP 600n Print Server for Token Ring manual Configure the Card for Network Operation

Page 8

Note	If other messages appear, see the troubleshooting
	sections in the HP JetDirect administrator’s guide
	provided on the HP JetDirect CD-ROM.
	For HP J3113A 10/100Base-TX cards, see appendix
	A in this manual for special troubleshooting
	information.

6.Configure the Card for Network Operation.

You can use the installation and configuration software on the HP JetDirect CD-ROM, or download it from the World Wide Web.

Refer to the HP JetDirect administrator’s guide (supplied electronically on the CD-ROM).

For many HP printers, you can use the printer’s control panel to configure basic network parameters.

Refer to chapter 3 in this guide.

If the JetDirect card has been configured with an IP address, you can use a supported Web Browser for advanced configuration.

Refer to chapter 4 in this guide.

6

Image 8

Contents HP JetDirect 600N Hardware Installation Guide Page Hardware Installation Guide HP JetDirect 600N Print Server Publication number Quick Installation Identify Your HP JetDirect 600N Internal Print ServerHP J3110A for Ethernet 10Base-T networks HP J3112A for Token Ring Ieee 802.5 networksIf Necessary, Set Switches or Jumpers on Your Card Before Installing the Card, Verify That Your Printer WorksPrint a Printer Configuration If You Have a Token Ring CardTurn on the printer and print another configuration Verify That the Card Is Operating ProperlyConfigure the Card for Network Operation Table of Contents Using the Embedded Web Server Introduction Supported Network Protocols TCP/IPSupported Printers IntroductionIntroduction Installing the Print Server What You Need for Installation Identify Your HP JetDirect 600N Internal Print Server You can use only one Token Ring port RJ-45 or DB If Necessary, Set Switches or Jumpers on Your Card 10/100 Half/Full AutonegotiationBefore Installing the Card, Verify That Your Printer Works HP LaserJet Printers and MopiersService Config HP DesignJet PrintersTypical Card Installation and Network Connection Turn Off Your Printer and Insert the CardVerify That the Card Was Installed Correctly For HP J3113A 10/100Base-TX cards See For LocalTalk-Only Customers If you areConfigure the Card for Network Operation HP JetDirect Administrator’s Guide provided on Installing the Print Server Control Panel Configuration Introduction To Restore Configuration Default Values To Enable or Disable Network ProtocolsTo enable or disable network protocols Press Select. CFG NETWORK=YES* appearsConfiguring IPX Frame Types IPX Frame Types on an HP JetDirect Ethernet CardIPX Frame Types on an HP JetDirect Token Ring Card Frame Type DescriptionTo configure an IPX frame type CFG IPX/SPX=NO* is displayedSource Routing Description Configuring IPX Source Routing Token Ring Cards OnlyTo configure IPX source routing Press Item until SRC RC=Source Routing* appears Configuring TCP/IP Parameters Parameter DescriptionTo configure TCP/IP parameters CFG TCP/IP=NO* is displayed CFG ETALK=NO* is displayed To configure EtherTalk parametersPress Item. Etalk PHASE=1* or Etalk PHASE=2* appears Control Panel Configuration Using the Embedded Web Server HP Web JetAdmin Compatibility Supported Web BrowsersViewing the Embedded Web Server Embedded Web ServerOperating Notes LED State Description Off Not linked HP J3113A 10/100Base-TX Print Server Supported LinksLink-Speed LEDs Jumper Location Link Configuration Jumper SettingsJumper Setting Descriptions Link Troubleshooting Parameter Expected Messages for 10/100TX CardsHP J3113A 10/100Base-TX Print Server Specifications and Regulatory Statements HP JetDirect 600N Internal Print ServerElectrical EnvironmentalFCC Statements Regulatory StatementsElectromagnetic Specifications Regulatory European CommunitySpecifications and Regulatory Statements Vcci Class a Japan RRL Statement Korea Taiwan Class a AustraliaCanada Chinese Safety Statement Page 5969-3561