HP 600n Print Server for Fast Ethernet manual Supported Printers, Introduction

Page 13

Supported Printers

The HP JetDirect 600N print servers are supported in all HP printers and mopiers with Enhanced Input/Output (EIO) slots, such as:

HP LaserJet EIO printers

HP Color LaserJet EIO printers

HP Mopiers (EIO mopiers)

HP DesignJet EIO large format printers

For most of these printers, you can use the printer’s control panel to configure basic network parameters on the HP JetDirect 600N internal print server. Refer to chapter 3.

1 Introduction

Note

For installation in peripheral devices not covered in

 

this guide, refer to the manuals supplied with the

 

peripheral device.

 

 

Introduction 1-3

Image 13
Contents HP JetDirect 600N Hardware Installation Guide Page Hardware Installation Guide HP JetDirect 600N Print Server Publication number Identify Your HP JetDirect 600N Internal Print Server Quick InstallationHP J3110A for Ethernet 10Base-T networks HP J3112A for Token Ring Ieee 802.5 networksBefore Installing the Card, Verify That Your Printer Works If Necessary, Set Switches or Jumpers on Your CardPrint a Printer Configuration If You Have a Token Ring CardVerify That the Card Is Operating Properly Turn on the printer and print another configurationConfigure the Card for Network Operation Table of Contents Using the Embedded Web Server Introduction TCP/IP Supported Network ProtocolsIntroduction Supported PrintersIntroduction Installing the Print Server What You Need for Installation Identify Your HP JetDirect 600N Internal Print Server You can use only one Token Ring port RJ-45 or DB 10/100 Half/Full Autonegotiation If Necessary, Set Switches or Jumpers on Your CardHP LaserJet Printers and Mopiers Before Installing the Card, Verify That Your Printer WorksHP DesignJet Printers Service ConfigTurn Off Your Printer and Insert the Card Typical Card Installation and Network ConnectionVerify That the Card Was Installed Correctly For LocalTalk-Only Customers If you are For HP J3113A 10/100Base-TX cards SeeConfigure the Card for Network Operation HP JetDirect Administrator’s Guide provided on Installing the Print Server Control Panel Configuration Introduction To Enable or Disable Network Protocols To Restore Configuration Default ValuesPress Select. CFG NETWORK=YES* appears To enable or disable network protocolsIPX Frame Types on an HP JetDirect Ethernet Card Configuring IPX Frame TypesIPX Frame Types on an HP JetDirect Token Ring Card Frame Type DescriptionCFG IPX/SPX=NO* is displayed To configure an IPX frame typeTo configure IPX source routing Configuring IPX Source Routing Token Ring Cards OnlySource Routing Description Press Item until SRC RC=Source Routing* appears Parameter Description Configuring TCP/IP ParametersTo configure TCP/IP parameters CFG TCP/IP=NO* is displayed Press Item. Etalk PHASE=1* or Etalk PHASE=2* appears To configure EtherTalk parametersCFG ETALK=NO* is displayed Control Panel Configuration Using the Embedded Web Server Supported Web Browsers HP Web JetAdmin CompatibilityEmbedded Web Server Viewing the Embedded Web ServerOperating Notes Link-Speed LEDs HP J3113A 10/100Base-TX Print Server Supported LinksLED State Description Off Not linked Jumper Setting Descriptions Link Configuration Jumper SettingsJumper Location Parameter Expected Messages for 10/100TX Cards Link TroubleshootingHP J3113A 10/100Base-TX Print Server HP JetDirect 600N Internal Print Server Specifications and Regulatory StatementsElectrical EnvironmentalElectromagnetic Regulatory StatementsFCC Statements European Community Specifications RegulatorySpecifications and Regulatory Statements Canada AustraliaVcci Class a Japan RRL Statement Korea Taiwan Class a Chinese Safety Statement Page 5969-3561