HP 600n Print Server for Ethernet, 600n Print Server for Token Ring manual Australia, Canada

Page 51

Australia

This equipment complies with Australian EMC requirements.

Canada

This equipment complies with Canadian EMC Class-A requirements.

VCCI Class A (Japan)

RRL Statement (Korea)

Taiwan Class A.

B
Specifications	Regulatory

Specifications and Regulatory Statements B-5

Image 51

Contents HP JetDirect 600N Hardware Installation Guide Page Hardware Installation Guide HP JetDirect 600N Print Server Publication number HP J3112A for Token Ring Ieee 802.5 networks Quick InstallationIdentify Your HP JetDirect 600N Internal Print Server HP J3110A for Ethernet 10Base-T networksIf You Have a Token Ring Card If Necessary, Set Switches or Jumpers on Your CardBefore Installing the Card, Verify That Your Printer Works Print a Printer ConfigurationVerify That the Card Is Operating Properly Turn on the printer and print another configurationConfigure the Card for Network Operation Table of Contents Using the Embedded Web Server Introduction TCP/IP Supported Network ProtocolsIntroduction Supported PrintersIntroduction Installing the Print Server What You Need for Installation Identify Your HP JetDirect 600N Internal Print Server You can use only one Token Ring port RJ-45 or DB 10/100 Half/Full Autonegotiation If Necessary, Set Switches or Jumpers on Your CardHP LaserJet Printers and Mopiers Before Installing the Card, Verify That Your Printer WorksHP DesignJet Printers Service ConfigTurn Off Your Printer and Insert the Card Typical Card Installation and Network ConnectionVerify That the Card Was Installed Correctly For LocalTalk-Only Customers If you are For HP J3113A 10/100Base-TX cards SeeConfigure the Card for Network Operation HP JetDirect Administrator’s Guide provided on Installing the Print Server Control Panel Configuration Introduction To Enable or Disable Network Protocols To Restore Configuration Default ValuesPress Select. CFG NETWORK=YES* appears To enable or disable network protocolsFrame Type Description Configuring IPX Frame TypesIPX Frame Types on an HP JetDirect Ethernet Card IPX Frame Types on an HP JetDirect Token Ring CardCFG IPX/SPX=NO* is displayed To configure an IPX frame typeConfiguring IPX Source Routing Token Ring Cards Only To configure IPX source routingSource Routing Description Press Item until SRC RC=Source Routing* appears Parameter Description Configuring TCP/IP ParametersTo configure TCP/IP parameters CFG TCP/IP=NO* is displayed To configure EtherTalk parameters Press Item. Etalk PHASE=1* or Etalk PHASE=2* appearsCFG ETALK=NO* is displayed Control Panel Configuration Using the Embedded Web Server Supported Web Browsers HP Web JetAdmin CompatibilityEmbedded Web Server Viewing the Embedded Web ServerOperating Notes HP J3113A 10/100Base-TX Print Server Supported Links Link-Speed LEDsLED State Description Off Not linked Link Configuration Jumper Settings Jumper Setting DescriptionsJumper Location Parameter Expected Messages for 10/100TX Cards Link TroubleshootingHP J3113A 10/100Base-TX Print Server Environmental Specifications and Regulatory StatementsHP JetDirect 600N Internal Print Server ElectricalRegulatory Statements ElectromagneticFCC Statements European Community Specifications RegulatorySpecifications and Regulatory Statements Australia CanadaVcci Class a Japan RRL Statement Korea Taiwan Class a Chinese Safety Statement Page 5969-3561