Configuring TCP/IP Parameters
Using the control panel of your printer, you can manually configure these TCP/IP parameters:
Parameter | Description |
|
|
BOOTP | YES (default) enables TCP/IP configuration |
| automatically from the network using BOOTP/TFTP, |
| DHCP, or RARP. |
| If BOOTP=YES*, none of the remaining parameters can |
| be configured from the control panel. |
| NO disables BOOTP, and allows you to configure the |
| remaining parameters from the printer’s control panel. |
|
|
IP Address | The JetDirect card’s unique TCP/IP network address, |
| consisting of 4 bytes: |
| IP BYTE1.IP BYTE2.IP BYTE3.IP BYTE4 |
| (example: 015.024.227.113). |
|
|
Subnet Mask | A bit mask filter used to identify the subnet of the JetDirect |
| card if subnetting is used, consisting of 4 bytes: |
| SM BYTE1.SM BYTE2.SM BYTE3.SM BYTE4 |
| (example: 255.255.248.0) |
|
|
Syslog Server IP | The IP address of the log server to be used by the |
Address | JetDirect card consisting of 4 bytes: |
| LG BYTE1.LG BYTE2. LG BYTE3.LG BYTE4 |
|
|
Default Gateway | The IP address of the gateway used to communicate with |
| stations outside the local subnet consisting of 4 bytes: |
| GW BYTE1.GW BYTE2.GW BYTE3.GW BYTE4 |
|
|
Timeout | The TCP/IP idle |
| can range from 0 to 3600. The default is 90. |
| If set to “0”, the timeout feature of the HP JetDirect card |
| is |
| closed by the server. |
|
|