To configure an IPX frame type
If you have not already done so, enable the IPX/SPX protocol
(IPX/SPX=ON*) by following the instructions described in “To enable or disable network protocols” in this chapter.
1.Take the printer offline by pressing [Go]. The “Ready” LED should be off.
2.Press [Menu] repeatedly until EIO # JETDIRECT MENU is displayed (# identifies the EIO slot number of the card).
3.Press [Item] until CFG NETWORK=NO* appears.
NO* indicates that access to the EIO JetDirect network menus will be bypassed. You must change this to CFG NETWORK=YES* to access the EIO JetDirect menus:
a.Press [Value]. CFG NETWORK=YES appears.
b.Press [Select]. CFG NETWORK=YES* appears.
4.Press [Item] to scroll through each network protocol until
CFG IPX/SPX=NO* is displayed.
To access the IPX/SPX configuration menu, press [Value] and then press [Select] to display CFG IPX/SPX=YES*.
5.Press [Item] until FRAME=<Frame Type>* appears.
AUTO | ● To change the frame type, press [Value] until | |
EN_8023 | the desired option appears, and then press | |
[Select]. | ||
EN_II | ||
● Press [Item] to continue to the next | ||
EN_8022 | ||
parameter. | ||
EN_SNAP | ||
| ||
TR_8022 |
| |
TR_SNAP |
| |
|
|
Note:
An asterisk (*) indicates the active frame type selected.
The available frame type options depend on whether you have an Ethernet or Token Ring card installed.
3 Control Panel Configuration
6.To activate the printer and save your changes, press [Go].
Control Panel Configuration