Resolving paper-feed problems
This section provides solutions to common
For information on resolving jams, see “Clearing jams”.
Tray cannot be inserted
zWith the tray removed from the printer, turn the printer off and then on again. Reinsert the tray.
zMake sure that the tray is aligned with the printer opening.
Another paper-feed problem is occurring
Media is not supported for the printer or tray
zMake sure that you are using media that is supported for the printer and for the tray being used. (See “Printer specifications”and “Understanding specifications for supported media”.)
Media is not picked up from Tray 1 or Tray 2
zCheck that the guides are set to the correct marking in the trays for the size of paper you are loading. Also make sure the guides are snug, but not tight, against the stack.
zMake sure the media you are using is not curled. Uncurl paper by bending it in the opposite direction of the curl.
zMake sure that the tray has been pushed completely into the printer.
An envelope is not picked up from the envelope slot
zMake sure that there is not more than one envelope loaded in the envelope slot.
zMake sure that the envelope is not wrinkled or bent. Do not leave an envelope in the envelope slot overnight because doing so can cause the envelope to bend.
zMake sure that media in Tray 1 is not interfering with the envelope slot and causing more than one envelope to be fed. Remove any media from Tray 1 and try again.
Media is not coming out correctly
zIf the output tray extension is not extended, output pages will fall off the printer. Make sure that output tray extension is extended.
zRemove excess media from the output tray. The output tray is designed to hold a maximum of 100 sheets at a time.
zIf the
Pages are skewing
zMake sure that media loaded in Tray 1 or Tray 2 is aligned to the right and front guides.
ENWW |