HP sv6 manual Configuration, Boot Up

installation and user information

installation process

4.Configuration

For hp visualization center sv6 configurations, follow these procedures:

Table 2-6

Boot up	BOOT AND CONFIGURE THE MASTER
	SYSTEM BEFORE BOOTING THE SLAVE
	SYSTEMS. Have a list of hostnames and IP
	addresses to assign to the systems so they will be
	visible on your site’s network. Run
	set_parms addl_netwrk
	to set the master’s network information.
	Optional: Set up networking and root passwords
	on slave nodes using:
	/var/opt/ignite/sps/sv6files/sv_config
	See the “How to Use hp visualization center sv6
	Tools” section for more information on sv_config.
Specify Compositor serial port	If possible, leave the Compositor connected to the
	default port on the master workstation (serial port
	2, /dev/tty1p0). If you wish to move the
	Compositor to a different port, this change must be
	specified in the /etc/X11/X0screens file.
Configure system software	When each computer comes up, it can be
	customized for the local environment (networking
	info, user accounts, passwords, etc.) Ensure that all
	systems are compatible with your working
	environment before moving to the next step.

5.Boot Up

NOTE	BOOT AND CONFIGURE THE MASTER SYSTEM BEFORE
	BOOTING THE SLAVE SYSTEMS.
	• The boot console on the master will prompt you for a
	hostname, an IP address and other system and network
	settings.
	• After you have answered all of the startup questions, power
	on all of the other workstations and network switchboxes.

42 Chapter 2