HP sv6 manual Changing resolution, Standard Resolutions

installation and user information usage

	instance, if you have a three channel system, but you want to
	temporarily set the configuration to use only two of the channels, you
	could save the current X0screens file and move a two channel
	template into place:
	cp /etc/X11/X0screens /etc/X11/X0screens.orig
	cd /usr/lib/X11/Xserver/misc/slsd/templates
	cp X0screens.p16c2 /etc/X11/X0screens
	. . . or
	ln -s /etc/X11/X0screens.16c2 /etc/X11/X0screens
	Early versions of SLS/d required the /etc/X11/X0devices and
NOTE
	/etc/X11/X0screens files on the slave systems to be edited. This is
	no longer necessary, since the master system uses the information in
	its X0screens file to do automatic configuration on the slaves via the
	X server.

changing resolution

Use one of the methods below to specify the resolution in the /etc/X11/X0screens file. Each method automatically sets all graphics cards in the hp visualization center sv6 configuration to the specified resolution. If no video timing information is specified, the default settings will be used.

Do not use the setmon program to change resolutions on your systems. It does not have the functionality to change all necessary settings.

• Standard Resolutions:

To set a standard resolution, add the following lines to the ScreenOptions section of the /etc/X11/X0screens file. The

example below is the default for fx10 graphics cards in an hp visualization center sv6 configuration (1280x1024 at 75 Hz):

ScreenOptions

SlsdVideoTimingWidth 1280

SlsdVideoTimingHeight 1024

SlsdVideoTimingFrequency 75

Chapter 2 63