HP sv6 manual Copy and register locally

installation and user information

updating software

Use the default target list which is generated during the initial installation of sv6 systems, /var/opt/sps/sv6files/sv6_targets, or create a new file containing the gigabit hostnames of all systems in your sv6 configuration. The first name in the list must be the gigabit hostname of the master system. For single-channel configurations, the default master hostname is svm, and for multi-channel the default is svm_c1. For this example, our sv6_targets file contains:

svm sv1 sv2 sv3 sv4

Touch the .sdkey file on each system to allow for the SD “install to multiple targets” functionality. Use the /var/opt/ignite/sps/sv6files/all script to automatically run this command on all systems in the targets list.

all touch /var/adm/sw/.sdkey

Enable SD root permissions from the master system to all systems in the target list.

master=$(head –1 /var/opt/ignite/sps/sv6files/sv6_targets)

all /usr/sbin/swacl -l root -M user:root@$master:crwit

step 2: copy and register locally

This step meets the requirement of the SD “install to multiple targets” functionality. The patch or depot being applied must be registered on the local (not network mounted) hard drive of the master system. Tape depot format is not supported. The swcopy command converts tape depots into an acceptable format.

Key to steps below		Example
Menu Selections	(xxx)	(Actions)
Buttons	[xxx]	[OK]
Text or commands to be	Plain, bold	svm
entered

7.Start the SD copy GUI: swcopy

8.In the target selection window:

52 Chapter 2