installation and user information
stereo hardware installation
| Connect power supply transformers to their respective emitters at |
| this stage. As with all computer equipment, emitters should be |
| |
| It is recommended that all emitters be powered OFF when |
CAUTION | |
| connecting or disconnecting their cables to any other equipment. |
| This can reduce the possibility of harmful power surges to other |
| equipment when handling this signal source. |
|
|
5.Power up the emitters
The power switch for emitters is located on the back side of the device. The switch has three positions
changing to stereo monitor mode
Use the following instructions to change graphics cards and compositor settings to a stereo mode.
1.Add ScreenOption
log in to the master system as root
init 2
In addition to the SlsdVideo resolution settings or the videotiming file specified in /etc/X11/X0screens, add one of the following lines under the ScreenOptions section:
SlsdCompositorStereo Active
SlsdCompositorStereo Passive
Save the /etc/X11/X0screens file
2.Start up the new X server: init 3
This will set all graphics cards in the configuration to the new stereo setting and then bring up CDE.
76 | Chapter 2 |