Hickory Industries, Inc.
6. Loading and Unloading Spits
On the N/45G, you do not need to open the front sliding glass doors of the machine in order to
load the spits! If your unit is equipped with hinged side doors, these must be opened in order to insert and/or remove the spits. With the side(s) open, use a barbecue fork to grab a spit on one end, inside the single skewers. You can then use your free hand to hold the spit handle. With the motor switch on or off, first insert the round end of the spit and position it on the oil lite bushing on the center plate (see Figure 27). Then position the spit gear (next to the handle) so that it meshes with the shaft worm on the vertical drive shaft. Shift the spit from side to side so that the space formed between the spit collar and the spit gear fits fits (falls) onto the oil lite bushing on the spit plate. Reverse procedure to unload.
Figure 27
Shaft Worm
Spit Plate
Spit Gear
Spit Collar
Oil Lite Bushing
Figure 28
4900 Westside Avenue, North Bergen, New Jersey 07047 | N/45 Series Manual12/00 |
Tel: [201] | Page 33 of 38 |