Troubleshooting: Wiring
ABS/ATC WIRING
CAB ECU Wiring Harness Connectors
The
All wire harness connectors must be properly seated. The use of secondary locks is strongly advised.
CAUTION: All unused ECU connectors must be covered and receive proper environmental protection.
Frame ECU Wiring Harness Connectors
CAUTION: The frame wire harness connectors must be properly seated with the seals intact (undamaged). All unused connector terminals must be plugged with the appropriate sealing plugs. Failure to properly seat or seal the connectors could result in moisture or corrosion damage to the connector terminals. ECUs damaged by moisture and/or corrosion are not covered under the Bendix warranty. Secondary locks must be snapped securely in place.
Follow all Deutsch requirements for the repair of wire harnesses.
CAUTION: All unused connector terminals must be plugged with the appropriate sealing plugs.
Frame ECU Connector Covers
Frame ECUs are provided with covers that must be removed to permit connection of the vehicle wiring harness. The cover can be removed by sliding the slide lock mechanism to the unlock position.
The covers provide strain relief and connector protection of the vehicle wire harness and will accept round convoluted conduit with an I.D. of 19 mm.
ABS Wiring Requirements
As a matter of good practice and to insure maximum system robustness, always use the maximum size wire supported by the wire harness connectors for battery, ignition, ground, PMV, TCV, Interaxle Differential Lock and indicator lamp circuits.
All sensor and serial communications circuits (J1587 and J1939) must use twisted pair wiring (one to two twists per inch). See the appropriate SAE document for additional details.
WARNING: All wires must be carefully routed to avoid contact with rotating elements. Wiring must be properly secured approximately every 6 to 12 inches using UV stabilized,
It is recommended that wires be routed straight out of a connector for a minimum of three inches before the wire is allowed to bend.
Battery and ground wires should be kept to a minimum length.
If convoluted tubing is used, its I.D. must match the size of the wire bundle as closely as possible.
CAUTION: Wire harness lengths must be carefully selected for the vehicle. Harnesses that are too long increase the possibility of electrical interference and wire damage. Excess lengths of wire are not to be wound to form coils, instead
32