GE 2800 manual RAK204 Series SUB-BASE Installation and Electrical Data, RAB71/77 Wall Case

33

RAK204 SERIES SUB-BASE INSTALLATION AND ELECTRICAL DATA

RAB71/77 Wall Case

				CHASEWAY OPTION
				(Shown Without Chassis and Wall Case for Installation Location Only.)
						RAK4002B
						NOTE: TYPE “E”
						MOUNTING CLIP MUST
						BE USED WITH MOLDED
						CASE.		MOLDED
								CASE
			GREEN
			GROUND
			SCREW
	5/32" DIA. HOLE (SEE NOTE)		(TYPE “C”)
			METAL CASE
6"	FOR SECURING TYPE “D”
	CLIPS TO SLEEVE USING		6"
	TYPE “A” SCREWS
	TYPE “B” SCREW		SCREW CLIP
			TYPE “D”					SUB-BASE
								MOUNTING CLIP
			TYPE “A”					TYPE “E”
			SCREW
			TO SECURE
			SIDE CHANNELS
				TYPE “A”	TYPE “B”	TYPE “C”	TYPE	USE WITH
TYPE “A”							“D”	RAB71
SCREW
							TYPE	USE WITH
	TYPE “C”		TYPE “C”				“E”	RAB77
				6 REQ’D.	2 REQ’D.	8 REQ’D.
	SCREW		SCREW
SIDE CHANNELS ARE ADJUSTABLE		ACCESS PLATES
FROM 13-3/4" TO 2-3/8" IN LENGTH

BY BREAKING OFF SECTIONS OF SIDE	NOTE: IF METAL CASE DOES NOT HAVE SCREW HOLES, 5/32" DIA. HOLES MUST
CHANNELS.
	BE DRILLED 6" FROM EACH SIDE IN FRONT FLANGE. (SEE INSERT).

Electrical wiring may enter the sub-base through any of the knockout holes provided in the sub-base.

Knockout holes in the sub-base access plate may accommodate a receptacle, which allows the use of a power cord (if permitted by code for the particular installation). A knockout for a circuit breaker, fuseholder or a disconnect is also provided. See pages 22 and 23 for description of electrical contents of these sub-bases.

ge.com