APC ACPA4000 manual Component Identification, Front view, Rear view

Page 13

Component Identification

Front view

Condenser air intake

Condenser exhaust

Display interface

na0118c

Locking casters (front 2 casters only)

Access panel (for use by service personnel only)

Rear view

Replaceable air filter element

Drain line connector

Detachable power cord–2.4 m (8 ft)

20A circuit breaker

Network Management Card

na0119c

Main control board

Communication port, RS-232 connector

Input contact connectors

Output relay connectors

Temperature sensor connector

NetworkAIR ACPA4000

Image 13

Contents Installation, Operation, and Maintenance ACPA4000NetworkAIR Portable Air Conditioning Unit Page American Power Conversion Legal Disclaimer Page General Information InstallationContents Operation Maintenance and Troubleshooting Page Overview General InformationManual updates About the NetworkAIR ACPA4000Cross-referencesymbol used in this manual Safety symbols that may be used in this manualInspecting the Equipment Storing the Equipment Before InstallationSafety Filing a claimInventory Tools RequiredThe equipment ships with the items shown below Front view Component IdentificationRear view Dimensions are shown in mm in Dimensions and WeightsNet Weight Shipping WeightWhere to locate the equipment InstallationLock the rolling casters Hose connections Intake and Exhaust VentsAssemble the ceiling adapter NetworkAIR ACPA4000 Install the adapter in a drop ceilingAssemble the ducts Connect the fitting to the drain line Drain LineAttach the drain line. Attach Temperature/humidity sensor AccessoriesOverview Relays and ContactsOutput relays To connect an output relay Input contactsTo connect an input contact Start-upchecklist Start-UpHow to apply power to the equipment Overview OperationDisplay interface identification Turn on the equipment How to Use the InterfaceScrolling status screens Navigating the interface Main menu screenDate 18-Jun-2007 Time Date 18-Jun-2007 TimePassword entry Change settingsTurn off the equipment Default schedule Set Environmental ControlsSchedule 1 of Operating schedulesSchedule On/Off ModeTemperature and humidity alarms Set Up AlarmsSet the alarm delay Password and time-out Set Up the DisplaySet the date and time Display interface optionsResetting to default settings Device settingsPath Main Menu Setup System Device Path Main Menu Setup Factory DefaultsHow to download firmware Input contacts Set Up Contacts and RelaysUser input contacts User outputsDefault schedule status Checking Equipment StatusScrolling status screens System and environmental status screensManufacturer data Viewing alarm statusSilencing the alarm beeper Responding to AlarmsSilence Active Alarm Warning or alarm LEDAlarm and event log Active alarm screenResolving alarm conditions Alarm Message Alarm messagesAction Required Action Required Alarm MessageRemote temperature Setup Display Interface Reference ChartsScrolling status screens Monitoring informationSetup Programmable settingsStatus Control EnvironmentSystem SetupMaintenance Maintenance and TroubleshootingReplace the air filter Clean the cabinet Clean the condenser filter and test the LCDI plugUpdate the main control board firmware Problem TroubleshootingPossible cause Corrective actionTerms of warranty One-YearFactory WarrantyNon-transferablewarranty ExclusionsWarranty claims Claims Warranty ProceduresParts Electrical SpecificationsPhysical Component TypePage APC Worldwide Customer Support 990-0412D990-0412D 03/2008