APC ACPA4000 manual Setup, System

Page 43

	Setup
Menu Item	Setting Variable

System	• System password
	Password—Enter password
	Time-out—Never–4 hrs
	Invalidate (ends session)
	• Date & Time
	Date—Enter date
	Time—Enter time
	DST Adjust—On/Off
	• Local interface
	Contrast—0–7
	Key click—On/Off
	Beeper volume — Off/Low/Med/High
	• Device
	Temp unit — °C/°F
	Start Dly (Start Delay)— 000–999 sec

Factory	• Set configuration to factory defaults?
defaults	Yes, set defaults
	No, abort

Firmware	• Load new firmware?
updates	Yes, start download
	No, abort

NetworkAIR ACPA4000

Image 43

Contents Installation, Operation, and Maintenance ACPA4000NetworkAIR Portable Air Conditioning Unit Page American Power Conversion Legal Disclaimer Page General Information InstallationContents Operation Maintenance and Troubleshooting Page About the NetworkAIR ACPA4000 General InformationOverview Manual updatesCross-referencesymbol used in this manual Safety symbols that may be used in this manualFiling a claim Storing the Equipment Before InstallationInspecting the Equipment SafetyInventory Tools RequiredThe equipment ships with the items shown below Front view Component IdentificationRear view Shipping Weight Dimensions and WeightsDimensions are shown in mm in Net WeightWhere to locate the equipment InstallationLock the rolling casters Hose connections Intake and Exhaust VentsAssemble the ceiling adapter NetworkAIR ACPA4000 Install the adapter in a drop ceilingAssemble the ducts Connect the fitting to the drain line Drain LineAttach the drain line. Attach Temperature/humidity sensor AccessoriesOverview Relays and ContactsOutput relays To connect an output relay Input contactsTo connect an input contact Start-upchecklist Start-UpHow to apply power to the equipment Overview OperationDisplay interface identification Turn on the equipment How to Use the InterfaceScrolling status screens Date 18-Jun-2007 Time Main menu screenNavigating the interface Date 18-Jun-2007 TimePassword entry Change settingsTurn off the equipment Default schedule Set Environmental ControlsMode Operating schedulesSchedule 1 of Schedule On/OffTemperature and humidity alarms Set Up AlarmsSet the alarm delay Display interface options Set Up the DisplayPassword and time-out Set the date and timePath Main Menu Setup Factory Defaults Device settingsResetting to default settings Path Main Menu Setup System DeviceHow to download firmware User outputs Set Up Contacts and RelaysInput contacts User input contactsSystem and environmental status screens Checking Equipment StatusDefault schedule status Scrolling status screensManufacturer data Viewing alarm statusWarning or alarm LED Responding to AlarmsSilencing the alarm beeper Silence Active AlarmAlarm and event log Active alarm screenResolving alarm conditions Alarm Message Alarm messagesAction Required Action Required Alarm MessageRemote temperature Monitoring information Display Interface Reference ChartsSetup Scrolling status screensControl Environment Programmable settingsSetup StatusSystem SetupMaintenance Maintenance and TroubleshootingReplace the air filter Clean the cabinet Clean the condenser filter and test the LCDI plugUpdate the main control board firmware Corrective action TroubleshootingProblem Possible causeExclusions One-YearFactory WarrantyTerms of warranty Non-transferablewarrantyWarranty claims Claims Warranty ProceduresParts Component Type SpecificationsElectrical PhysicalPage 03/2008 990-0412DAPC Worldwide Customer Support 990-0412D