APC ACPA4000 manual Assemble the ducts

Page 18

Assemble the ducts

1.Thread the duct collars counterclockwise onto each of the ducts until they bottom out.

Note: The hoses used are directional and reduce airflow if not properly installed. Expand the length of hose to fit the required space.

2.Install each hose so that the leading edge of the compressed section of the hose matches air direction flow.

3.Slide the duct collar of each hose

over the ceiling adapter sleeves and turn the duct collar to lock in place.

Note: Connect the air diverter side of the ceiling adapter to the exhaust hose.

4.Slide the duct collars on the other

end of the ducts over the condenser flanges and turn to lock in place.

na0312a

Air Flow

na1235a

na0317a

na0150b

10	NetworkAIR ACPA4000

Image 18

Contents ACPA4000 Installation, Operation, and MaintenanceNetworkAIR Portable Air Conditioning Unit Page American Power Conversion Legal Disclaimer Page Installation General InformationContents Operation Maintenance and Troubleshooting Page Manual updates General InformationOverview About the NetworkAIR ACPA4000Safety symbols that may be used in this manual Cross-referencesymbol used in this manualSafety Storing the Equipment Before InstallationInspecting the Equipment Filing a claimTools Required InventoryThe equipment ships with the items shown below Component Identification Front viewRear view Net Weight Dimensions and WeightsDimensions are shown in mm in Shipping WeightInstallation Where to locate the equipmentLock the rolling casters Intake and Exhaust Vents Hose connectionsAssemble the ceiling adapter Install the adapter in a drop ceiling NetworkAIR ACPA4000Assemble the ducts Drain Line Connect the fitting to the drain lineAttach the drain line. Attach Accessories Temperature/humidity sensorRelays and Contacts OverviewOutput relays Input contacts To connect an output relayTo connect an input contact Start-Up Start-upchecklistHow to apply power to the equipment Operation OverviewDisplay interface identification How to Use the Interface Turn on the equipmentScrolling status screens Date 18-Jun-2007 Time Main menu screenNavigating the interface Date 18-Jun-2007 TimeChange settings Password entryTurn off the equipment Set Environmental Controls Default scheduleSchedule On/Off Operating schedulesSchedule 1 of ModeSet Up Alarms Temperature and humidity alarmsSet the alarm delay Set the date and time Set Up the DisplayPassword and time-out Display interface optionsPath Main Menu Setup System Device Device settingsResetting to default settings Path Main Menu Setup Factory DefaultsHow to download firmware User input contacts Set Up Contacts and RelaysInput contacts User outputsScrolling status screens Checking Equipment StatusDefault schedule status System and environmental status screensViewing alarm status Manufacturer dataSilence Active Alarm Responding to AlarmsSilencing the alarm beeper Warning or alarm LEDActive alarm screen Alarm and event logResolving alarm conditions Alarm messages Alarm MessageAction Required Alarm Message Action RequiredRemote temperature Scrolling status screens Display Interface Reference ChartsSetup Monitoring informationStatus Programmable settingsSetup Control EnvironmentSetup SystemMaintenance and Troubleshooting MaintenanceReplace the air filter Clean the condenser filter and test the LCDI plug Clean the cabinetUpdate the main control board firmware Possible cause TroubleshootingProblem Corrective actionNon-transferablewarranty One-YearFactory WarrantyTerms of warranty ExclusionsWarranty claims Warranty Procedures ClaimsParts Physical SpecificationsElectrical Component TypePage 990-0412D 990-0412DAPC Worldwide Customer Support 03/2008