Wall plate | Stovax PR0919 instruction

INSTALLATION INSTRUCTIONS

INSTALLATION

•Fit the supplied top support bar into the stud work at the correct height, Diagram 7, because no combustible material can be used above the fire

AR1904

•Attach the 4 frame fixing brackets to the fire, Diagram 8

•Fix foam seal to the outer flange of the fire

AR1913

•Position the fire

•Fit non-combustible board to the stud work around the fire. This should extend a minimum of 400mm above the appliance and at least 50mm to the sides of the appliance (from the outer box, not the flanges).

•Apply plasterboard to the remainder of the stud work

•Secure the fire back to the stud work using four screws through flange, bracket, support bar

•Apply a plaster finish to the front of the chimney breast

•Decide on the position for the wall box containing the batteries and wall switch

•Connect the wire from the fire to the battery pack,

Diagram 9

AR1920

•Connect the wire from the fire to the touch pad/ connector, Diagram 10

AR1919

•Correctly position the four new AA size batteries

•Re-assemble the battery holder as shown in Diagram 11

•Ensure the touch pad cable is tucked to the left on fitting the wall plate back onto the wall

AR1932

•Secure the wall plate with the touch pad attached to the wall box, Diagram 12

wall plate	AR1887

Because of the high temperatures this fire achieves, it is advisable to use marble slips or similar material between the appliance and the plasterboard

Never use a one-piece slip as expansion (even cracking) can occur. If a slip is used, longer screws are needed to secure the appliance.

•Connect the flue system and gas services using the opening in the side of the chimney breast for access. After commissioning, finish the sides of the chimney breast, Diagram 13