Quadra-Fire CB1200I-B owner manual Frequently Asked Questions, Do not Leave Firepot Floor Open

CB1200-I Pellet Insert

R

WARNING

Fire Risk

Do NOT operate appliance:

• With appliance door open.

•Firepot floor open.

•Cleaning slide plates open. Do NOT store fuel:

•Closer than required clearances to com- bustibles to appliance

•Within space required for loading or ash removal.

Back side of Firepot

Firepot floor left open

Figure 25.1 - DO NOT LEAVE FIREPOT FLOOR OPEN

I. Frequently Asked Questions

	ISSUES		SOLUTIONS
1.	Metallic noise.	1.	Noise is caused by metal expanding and contracting as
			it heats up and cools down, similar to the sound pro-
			duced by a furnace or heating duct. This noise does not
			affect the operation or longevity of your appliance.
2.	Ash buildup on glass.	2.	This is normal. Clean the glass.
3.	Glass has turned dirty.	3.	Excessive build up of ash. The lower burn settings will
			produce more ash, the higher burn settings produce
			less. The more it burns on low the more frequent clean-
			ing of the glass is required.
4.	Fire has tall flames with black tails and is lazy.	4.	The feed rate needs to be reduced or the firepot needs
			cleaning. Heat exchanger or exhaust blower needs
			cleaning.
5.	Smokey start-up or puffs of smoke from the airwash.	5.	Either the firepot is dirty or there is too much fuel at
			start-up and not enough air. Close down feed rate 1/4
			inch (6mm) at a time until this no longer happens.
6.	Large flame at start-up.	6.	This is normal. Flame will settle down once the fire is
			established.

Page 26 7014-083C October 26, 2006