Quadra-Fire CB1200I-B owner manual Igniter Replacement

R

CB1200-I Pellet Insert

Firepot Overfills	Pellets Back Up
	In Feed Tube
Ash Build Up in Firebox

Figure 33.1

Incorrect

Tall, Lazy Flame, Orange in Color

Figure 33.2

Correct

Correct Flame Size, Yellow/White in Color

Figure 33.3

WARNING

Fire Risk.

•High ash fuels, or lack of maintenance, can cause the firepot to fill with ash and clinker. If the firepot fills to the top, immediately shut down the unit and clean.

•Failure to do so could result in smoking, sooting and possible hopper fires.

D. Igniter Replacement

Igniter Bracket

Thumb Screw Igniter

Figure 33.4

a.Shut down the appliance by turning down the thermostat and let the appliance completely cool down. After the appliance has cooled down, unplug it and remove the ash pan.

b.The wire leads to the igniter are connected to the wire harness with 1/4 inch male / female spade connectors. These wires will pull forward approximately 4 to 5 inches (102mm to 127mm). Disconnect the spade connections and remove the igniter from the chamber. Loosen the thumb screw and slide igniter out.

c.Install new igniter into the chamber and tighten the thumb screw. Re-connect the wires to the 2 leads with the spade connectors.

d.Push excess wire leads to take-up the 4 to 5 inches (102mm to 107mm) previously pulled out. This will keep the wires out of the way of the ash pan. Double check that the igniter wires are clear of any movement, i.e. ash pan, firepot cleaning rod, etc.

f. Re-install the ash pan and re-connect the power.

October 26, 2006 7014-083C Page 33