Quadra-Fire CB1200I-B owner manual

R

CB1200-I Pellet Insert

Symptom	Possible Cause	Corrective Action
Convection blower fails to	No call light.	Defective control box.
start.	#1 snap disc defective.	Replace snap disc.
	Blower not plugged in.	Check that blower is plugged into wire har-
		ness.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Exhaust blower fails to	Blower not plugged in.	Check that blower is plugged into wire har-
start or does not shut off.		ness.
	Blower is clogged with ash.	Clean exhaust system.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Large, lazy flame, orange	Dirty appliance.	Clean appliance, including firepot, heat
color. Black ash on glass.	Poor fuel quality, high ash content.	exchangers and venting system. Remove
		stainless steel baffle from firebox to clean
		ash from on top of baffle. Clean behind rear
		brick panels. Change fuel brand to pre-
	Firepot clean-out plate not completely	mium.
	closed.	Check that firepot clean-out plate is fully
		closed.
	Excessive amount of fuel.	Reduce feed rate using feed rate adjustment
		control rod located inside hopper.
Nuisance shutdowns.	Low flame.	Increase feed by opening feed rate adjust-
		ment control rod located inside hopper.
	Sawdust buildup in hopper.	Clean hopper, see page 32.
	Feed motor is reversing.	Check for good connections between feed
		motor and wire harness.
	Defective thermocouple.	Replace thermocouple.
	Defective control box.	Replace control box.
	Firepot more than 1/2 full	See pages 32 & 33 for detailed instructions
		for “High Ash Fuel Content Maintenance”.
Appliance calls for heat.	Thermocouple is defective or not properly	Check connections on thermocouple or
Call light illuminates.	plugged in.	replace if defective.
Exhaust blower starts.		A flashing yellow light on the control box
No feed or igniter.		indicates a problem with the thermocouple.
	Defective control box	Replace control box.

October 26, 2006 7014-083C Page 29