Quadra-Fire QF130 owner manual Optional Accessories Requirements, Blk

C. Optional Accessories Requirements

•This appliance may be used with a wall switch, wall mounted thermostat and/or a remote control.

•To connect optional accessories, the supplied cord as- sembly should be used. See Figure 10.2 for a wiring diagram for a blower or remote.

Wiring for optional Hearth & Home Technologies approved accessories should be done now to avoid reconstruction. Follow instructions that come with those accessories.

•Plug the cord into a convenient outlet.

•Must use cord supplied.

•An IntelliFire Plus™ Wireless Controls or WSK-21 wired wall switch may be used with the IntelliFire Plus™ Ignition System. Hearth & Home Technologies recommends that IntelliFire Plus™ wireless controls be used for their features and functionality with the Intel- liFire Plus™ ignition system.

•A standard ON/OFF switch is compatible.

WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105° C rated wire. Wire must have high temperature insulation.

BLOWER	PLUG
	120V EXISTING
NOTE: IF ANY OF THE ORIGINAL	OUTLET
WIRE AS SUPPLIED WITH THE
APPLIANCE MUST BE REPLACED,
IT MUST BE REPLACED WITH TYPE
1050 C RATED WIRE.

NOTE: USE ZIP TIES TO RESTRAIN THE LOOSE WIRES UNDERNEATH THE APPLIANCE AND KEEP THEM AWAY FROM THE BLOWER WHEEL (FAN BLADES).

	JUMPER WIRE
	TEMPERATURE
	SENSOR SWITCH
	TO VALVE
WHT (2)	ORG
	BLK
GRN (2)
BLK (2)

VARIABLE SPEED

CONTROL

BLK

BLK BLK

BLK

TEMPERATURE

SENSOR SWITCH

BLK (2)

GRN (2)

BLK (2)

PLUG INTO 120V

EXISTING OUTLET

DC REGULATOR

RECEPTACLE

BLOWER

RECEPTACLE

GRN	SPEED CONTROL
	(RHEOSTAT)
BRN	TO VALVE BRACKET
BLK	(GROUND)
RED

WHT BLK

GRN GRN

BLK BLK

BLOWERS

BLK BLK

GRN GRN

WHT BLK

Figure 10.2 Fan Wiring Diagram

26 Quadra-Fire • QFI30, QFI35 • 2227-900 Rev. H • 1/11