FLAT SPOT
FOR LOG #2 FLAT SPOT
FOR LOG #5 
1
LOG CORNER ALIGNS |
WITH PILOT BRACKET |
NOTCH MATES WITH LEFT |
GRATE TINE |
Figure 6. Placement of Log #1 | Figure 7. Location of Notch on Log #1 |
Log #1 (SRV2227-703): Mate the notch located on the bottom of the log, with the left grate tine. See Figure 7. The back end of log should line up with the left edge of the pilot bracket as shown in Figure 6.
LOG CONTACTS REFRACTORY
LOG RESTS ON BURNER 
LOG GROOVE
(FOR LOG #6)
LOG RESTS ON
REFRACTORY SUPPORT
3
NOTCH MATES WITH |
RIGHT GRATE TINE |
Figure 8. Place Log #2 | Figure 9. Log #3 |
Log #2 (SRV2227-702): Rest left end of log on the fl at spot of Log 1. See Figure 6 and Figure 8. The left end of the log should touch the left refractory panel. The right end rests on the burner. Push the right end back, until it touches the edge of the log support.
Log #3 (SRV2227-701): Mate the notch with the right grate tine as shown in Fig 9. The back of the log should rest on the log support as shown. Rotate the back end of the log clockwise until it contacts the right refractory panel.
LOG PIN | LOG GROOVE |
(FOR LOG #6) |
MATES | |
WITH SLOT | |
4 
Figure 10. Log #4 | Figure 11. Log #4 | |
Quadra-Fire • QFI30, QFI35 | • 2227-900 Rev. H • 1/11 | 31 |
