Heat & Glo LifeStyle ESCAPE-I35-C Electrical Information, Wiring Requirements, Code CSA C22.1

10 Electrical Information

A. Wiring Requirements

NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric

Code CSA C22.1.

•This appliance comes with a 120 VAC cord assembly. This is required for proper operation of the appliance (Intellifire PlusTM Ignition). An outlet box may be installed in a bottom back corner of the existing solid fuel masonry or factory built fireplace to plug in the cord assembly, or the supplied power cord may be routed out onto the hearth to a nearby outlet.

•A 120 VAC circuit for this product must be protected with ground-fault circuit-interrupter protection, in compliance with the applicable electrical codes, when it is installed in locations such as in bathrooms or near sinks.

•Low voltage and 120 VAC voltage cannot be shared within the same wall box.

WARNING! Risk of Shock or Explosion! DO NOT wire 120V to the valve or to the appliance wall switch. Incor- rect wiring will damage controls.

B. IntelliFire PlusTM Ignition System Wiring

•Wire an outlet box (120VAC) in the bottom back corner of the existing solid fuel masonry or factory built fireplace to plug in the cord assembly, or the supplied cord assembly may be rerouted out onto the hearth to a nearby outlet for proper operation of the appliance.

WARNING! Risk of Shock or Explosion! DO NOT wire IPI controlled appliance junction box to a switched circuit. Incorrect wiring will override IPI safety lockout.

•Refer to Figure 10.1, IPI Wiring Diagram.

•This appliance is equipped with an IntelliFire PlusTM control valve which operates on a 6 volt system.

•Plug the 6 volt transformer plug into the appliance cord assembly to supply power to the unit OR install 4 AA cell batteries (not included) into the battery tray before use. See Section 2.H for instructions on locating battery tray and installing batteries.

•Battery longevity and performance will be affected by the service temperatures of this appliance. Batteries should only be used as a power source in the event of an emergency such as an outage.

MODULE RESET SWITCH

WIRE ASSEMBLY

TO CORD ASSEMBLY

120VAC

ORANGE

INTERMITTENT PILOT IGNITOR

MODULE ORG
WHT
AUX WIRE EXTENSION
	BATTERY PACK
BLACK	6V DC (AA X 4)
GREEN

AUX 300 MODULE

FAN

AUX1 AUX2

RC300 4.5V DC (AAA X 3)

OPTIONAL

AUX2 NOT USED FOR INSERT MODELS. PROTECTIVE COVER INCLUDED.

TO CORD ASSEMBLY

120VAC

(PILOT)

(MAIN)	RED
	BROWN

GROUND

EMC FILTER UNIT

LIGHT WIRE ASSEMBLY

EMBER BULB 50W (2)

ACCENT SOCKETS (2)

Figure 10.1 IPI Wiring Diagram

NOTE: SEE FIGURE 10.3 FOR ADDITIONAL INFORMATION

28 Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. H • 5/12