Heat & Glo LifeStyle SLR-C (COSMO) owner manual D. Mantel and Wall Projections

D. Mantel and Wall Projections

WARNING! Risk of Fire! Comply with all minimum clear- ances to combustibles as specified. Framing or finishing material closer than the minimums listed must be construct- ed entirely of noncombustible materials (i.e., steel studs, concrete board, etc).

Combustible Mantels

1/2 IN. Thick Wall

Sheathing 12 IN.

MAX.

MEASUREMENT

14 IN. FROM TOP OF MIN. FIREPLACE

OPENING

Figure 5.3 Clearances To Combustible Mantels Or Other Combustibles Above Appliance

Non-combustible Mantels

	1/2 IN.
	Thick Wall	12 IN.
	Sheathing
		MAX.
		14 IN.
		MIN.
	MEASUREMENT
	FROM TOP OF
	FIREPLACE
	OPENING	1 IN.MIN.
	4 IN.
	MAX.
Figure 5.4	Clearances To Non-Combustible Mantels Or Other
	Non-Combustibles Above Appliance

Note: For non-combustible fireplace finish material (marble, stone, etc) specifications refer to Section 13.C.

Combustible Mantel Legs Or Wall Projections Extending Past The Face Of The Fireplace

		2 IN.
FIREPLACE	MINIMUM		3 FT. MAXIMUM
OPENING
		6 IN.
	MINIMUM

Figure 5.5 Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening)

Non-combustible Mantel Legs Or Wall Projections Extending Past The Face Of The Fireplace

		3 IN.
				UNLIMITED
FIREPLACE	MINIMUM
OPENING			7 IN.

Figure 5.6 Non-Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening)

1 IN.

FRAMING

NAILING TAB

1/2 IN. FACTORY-SUPPLIED

NON-COMBUSTIBLE BOARD

Figure 5.7 Front Side Finishing Detail

20 Heat & Glo • SLR-C • 2292-900 Rev. D • 8/12