Heat & Glo LifeStyle SLR-C (COSMO) D. Electrical Service and Repair, E. Junction Box Installation

IGNITION MODULE 3 VAC INTERMITTENT PILOT IGNITOR

HOT

BATTERY PACK

NEUTRAL

TRANSFORMER

3 VAC

PLUG IN	BLACK
	RED

THERMOSTAT

WIRE ASSEMBLY

I

S

WHITE

ORANGE

GROUND TO

FIREPLACE

CHASSIS

WIRES

(TO BROWN)

ORANGE

VALVE

GREEN

NOTE: 1. Ignition module, valve, pilot, and wall switch operate on 3 volts. 120 VAC is required at junction box unless equipped with battery back-up.

Figure 12.2 IntelliFire Pilot Ignition (IPI) Wiring Diagram with Wall Switch or Thermostat

D. Electrical Service and Repair

WARNING! Risk of Shock! Label all wires prior to dis- connection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105° C rated wire. Wire must have high temperature insulation.

E. Junction Box Installation

1.Bend junction box heat shield to the right along the perforated hand bends.

2.Remove the one screw located in front of the junction box.

3.Remove the plastic electrical knockout slug in the top of the junction box.

4.Install wire strain (not included) and route wire through wire strain fitting.

5.Make the connections inside the junction box to the 120V wire. Connect the green wire to the ground nut, the black wire to the black wire and the white wire to the white wire.

6.Reinstall the junction box.

7.Reposition the junction box heat shield such that it is positioned over the junction box.

Note: There is an alternative access to the junction box. This can be accessed by removing the valve assembly. See Section 11.

Heat & Glo • SLR-C • 2292-900 Rev. D • 8/12 49