WARNING
Shock or fire risk.
Use ONLY optional accessories approved for this appliance.
•Using
•Using
•Only Hearth & Home Technologies approved
accessories may be used safely.
D. Install the Refractory
Figure 12.4
STEP 1.
Place the back piece of refractory in back of the firebox. The small indentation on one side goes down. Lean the refractory slightly so it doesn’t tip over.
Figure 12.5
STEP 2.
Place the left side refractory onto the left side of the burner. Push the back refractory against the back wall. Place the bumps on the bottom of the left refractory into the grooves on the burner surface. Push to top gently against the side of the fireplace. Once in place push it back so the bevel cuts sit against each other and the seam is minimized.
STEP 3.
Repeat step 2 for the right side.
Figure 12.6
E. Ember Placement
WARNING
Explosion Risk.
•Follow ember placement instructions in manual.
•Do NOT place embers directly over burner ports.
•Replace ember material annually.
Improperly placed embers interferes with proper burner operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place the ember material:
•Embers CANNOT be placed directly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).
•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the
EMBER MATERIAL |
Figure 12.1 Placement of Embers |
•Place Mystic Embers on areas of base refractory away from port holes. Use this material to give the appliance a realistic ash bed.
•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.
36 | Heat & Glo • |