Glass Information, Louvre Removal | Vermont Casting DVRTSB instruction

DVRTSB Bay Window Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Under no circumstances should this appliance be operated without the front glass in place, or with the glass in a damaged condition.

•Replacement glass (complete with gasket) is available through your Majestic Fireplaces dealer and should only be installed by a licensed qualiﬁed service person.

Louvre Removal

•The top side and top end louvres are removed by simply lifting the louvre assembly and pulling the assembly away from the ﬁreplace. (Fig. 35)

•The lower side louvres are hinged along the lower edge and are folded down for access to components in the base cavity of the ﬁreplace.

•The lower end louvre assemblies on the DVRTSB unit are removed in the same manner as the top louvre assemblies.

Louvre

6.Tilt the lower edge of frame out slightly and lift glass/frame assembly up and away from the ﬁreplace. (Fig. 36)

7.To reinstall the glass panel reverse this procedure.

	Lower Clamps
		Window
		Frame
Window		Pull Clamp
Frame	Push	Pull Clamp
	Push	Hook
	Clamp
	Handle

FP1391

Fig. 36 Remove glass/frame assembly.

Side Glass Frame

1.	Remove the top and bottom louvre assemblies.
2.	Remove the lower window trim (held in place
	with magnets).
3.	Remove both lower retaining screws. Access to
	these screws is gained through the holes along the

Glass Panel

Fig. 35 Louvre removal.

FP1390

	lower edge of the frame behind the trim. (Fig. 37)
4.	Tilt lower edge of frame out slightly and lift glass/
	frame assembly up and away from the ﬁreplace.
5.	To reinstall the glass panel reverse the process.

Glass/Frame Removal

Front Glass Frame

1.Shut off the gas supply.

2.Allow the ﬁreplace to cool if it has been in operation.

3.Remove the top louvre assembly.

4.Lower the bottom louvre assembly.

5.Release the two clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 36)

Location of Lower
Retaining Screws	FP1392

Fig. 37 Remove end glass.

10003848