Lava Rock & Ember Material
Your log set contains two types of “Lava Rocks”.
The placement of this material is best done after the logs have been installed.
Ceramic Ember Rocks (Pt. # 57897)
Remove these ‘rocks’ from the packaging and spread them over the burner tiles in a random fashion to fill up the spaces between the logs. (Fig. 40) Only place ceramic embers in areas shown in Figure 40.
Lava Rock (Pt.# 10001454)
Remove this material from the packaging and spread it over the ceramic floor panels outside the log stack. DO NOT PLACE THIS
MATERIAL ON THE BURNER TILES.
DVRTSB Bay Window Fireplace
Ceramic Ember Rock Location | LG299 |
Fig. 40 Location of log cradle prongs in relation to assembled logs.
Flame Characteristics
Flame & Temperature Adjustment
RN/RP Models
For units equipped with ‘HI/LO’ valves the flame adjustment is accomplished by rotating the ‘HI/LO’ adjustments knob located near the center of the gas control valve. (Figs. 41 & 42)
Turn |
|
|
|
counterclockwise | �� | �� | Turn clockwise |
to decrease |
| to increase | |
|
| ||
flame height |
|
| flame height |
Fig. 41 Flame adjustment knob for Honeywell valve.
Turn | IH | Turn clockwise |
counterclockwise |
| |
to increase |
| to decrease |
flame height | LO | flame height |
|
| |
| ||
Fig. 42 Flame adjustment knob for SIT valve. | ||
It is important to periodically perform a visual check of the pilot and burner flames. Compare to the illustrations below. (Figs. 43 & 44) If the flame patterns appear abnormal contact a qualified service provider for service and adjustment.
3/8" - 1/2" 
SIT Pilot | PSE Pilot |
FP1394
Fig. 43 Correct pilot flame appearance.
LG300
Fig. 44 Correct burner flame appearance.
10003848 | 23 |