INSTALLATION
VENT RESTRICTOR POSITION
Vent restriction is required for certain venting installations, see the diagrams in the "Venting Arrangements" section to determine if they are required for your installation.
The Vent Restrictor plate is located on the inside top of the firebox.
Vent Restrictor Plate
Latch
2- ½”
b. Swing the door out from the top and release | Vent Restrictor Set 1 |
the hinge on the left side of the door and |
|
lift out. | Factory Set Vent Restrictor Set |
| (no adjustment required) |
INSTALLATION
To set the vent restriction as indicated in the venting arrangements diagrams, refer to the following instructions;
1) Remove the faceplate.
2)Remove the glass door.
2”
Vent Restrictor Set 2
a.Release the 2 door latches on the left and right side at the top of the firebox.
Latch Location
HingeDoor
3) Remove the screws that hold the vent | 1- 1/4 | ||
restrictor plate in place. | |||
|
| ||
4)Adjust the vent restrictor plate to the required vent restrictor position as per the diagrams shown.
Vent Restrictor Set 3
5)Once the vent restrictor plate is in the required position, secure with screws.
Screws for plugging the holes.
(all holes must be plugged with a screw).
Screw holes for fixing the restrictor plate.
Regency® L676S Direct Vent Gas Fireplace | 15 |